| |
2.9.1３［Ctl-P to Z Surface］
|
|
|
It moves to the curved surface (direction of Z) that specifies the control
point of the solid (curved surface) that has been selected.
| Tool |
 |
When this command is started, the command that was starting before that is automatically ended.
The procedure is shown below.
1.The solid (object) that becomes a working reference plane is selected.
(Refer to the solid selection method for details. )
2. Push Ctl-P to Z surface Comannd
It is displayed in the dark gray object. 
3.The solid (curve and curved surface) to be edited is selected.
4.Push Ctl-P to Z Surface Command
5.The tracker is displayed at the control point position. The tracker color
is blue.
It is a control dot sequence of the cross-sectional direction.
6.The tracker that moves (match) is selected.
･Left button click: Selection of control point
･Left button Drag: Selection of control point
･Control point selection addition key(Usually: CTRL + left button click)
The tracker color has been selected in yellow. 
7.The control point specified that a right button is clicked meets curved
surface Z coordinates.
This command is not automatically ended.
Since Ver1.1
The range limitation function was made.
The control point is made non-display by acquiring the center of the object
automatically now and specifying the direction of side in the front side
back of the direction seen from each axis.
This item of effective comes to display it by putting the check.
Moreover, the back and Front
Front : small direction
Back: Maximum direction
When setting it as follows. The control point on X preaxial side (Because
it is the maximum value) becomes non-display.
In the control point movement, when the range is exceeded, it becomes non-display.
(necesary more development. )
|
