It sets a tension coefficient. The setting possible range is 0-3 and the
original value becomes 0.
TOOL
Even if it starts this command, the command which was starting before it is continued.
The tension coefficient is the one which shows what influence to have on the Control point except the Control point (line)
which becomes an object at the time of [Object (Wire) Deform].
[Tension Coefficient]Dialog Box
The meaning of the tension coefficient is shown below.
1. 0 : It is not in the influence.
2. 1 : Reference Figure 1
3. 2 : Reference Figure 2
4. 3 : Reference Figure 3
A command with effective tension coefficient is shown below.
(Object Generate) [Wire Deform]
(Object Deform) [Point Move[Ctl-P]] [Line Move[Ctl-P]] [Line Rotate[Ctl-P]] [Twist[Ctl-P]]
[Extend/Reduce[Ctl-P]] [Section Deform[Ctl-P]] [Move Rails[Ctl-P]]
The operating procedure when checking ”Range Limitation” becomes the following.
1. TRACKER is displayed in the Control point position.
TRACKER color : Blue : The un-chosen Control point
2. It drags TRACKER on three planes, or it clicks TRACKER on three planes/perspective drawing and it chooses it.
Left button click/drag - The choice of the Control point.
Ctrl Point Add Key (Generally :Ctrl ) + Left button click/drag - It is
chosen in the addition by the Control point before it.
TRACKER color : Dark Green : The choice Control point(The tension effective Control point).
This command doesn’t end automatically. As for the way of ending, refer
to The way of command’s ending. As for the TRACKER, refer to The way of
the TRACKER operation. In [Environment] command, Ctrl Point Add Key can
be changed, too. The range limitation becomes invalid when not starting
above-mentioned menu immediately after limiting a tension range.
