It bends chosen object with the circular cylinder.

TOOL

When starting this command, the command which was starting before it is automatically ended.
A procedure is shown below.
1. It chooses the object. (For the details, refer to The way of choosing object.)
2. When inputting a bend angle in the numerical value
It starts [Numeric Mode] command and it makes a numerical value input state.
The starting of [Numeric Mode] command can be omitted when starting a menu while pushing Numeric Mode Shortcut Key(Generally : Shift ), too.
3. When displaying a bend angle in the numerical value
It starts [Show The Number] command and it makes a numerical value display condition.
4. It starts [Bend[Vertex]] command.
5. When changing the range to bend, it drags TRACKER in the four corners and it moves it.
TRACKER is displayed only in the specified side. It is possible to return to the condition before dragging when starting [Delete] command after dragging TRACKER.
6. In case of the numerical value input state
The [Bend] Dialog Box is displayed when clicking TRACKER for the bend which is in the center with the side to bend. It specifies a circular cylinder bend angle. In case of the positive, the specified side becomes solitude inside and when negative, it becomes solitude outside.

[Bend]Dialog Box

7. In case of the mouse input state (except the numerical value input state)
It bends a circular cylinder while dragging TRACKER which is in the center with the side to bend on three planes (X-Y,Y-Z, Z-X). At this time, in case of the numerical value display condition, it displays the angle to bend at the numerical value.
In mouse input, this command doesn’t end automatically. As for the way of ending, refer to The way of command’s ending.
As for the TRACKER, refer to The way of the TRACKER operation. In [Environment] command, Numeric Mode Short-cut Key and Key can be changed, too.