When starting this command, the command which was starting before it is automatically ended and the generated sweep
body becomes a chosen condition (red).
A procedure is shown below. (It does any one of three planes (X-Y, Y-Z, Z-X).)
1. It chooses the object (Wire(Section)). (For the details, refer to The
way of choosing object.)
(It is necessary to carry out [Wire]command of Sweep Base Line and Section before this command starting.)
2. When [Wire Combine]command is done with [Facet].
F5 key is pushed, and the [Facet] mode is taken.
3. When [Wire Combine]command is done with [1 Section].
F6 key is pushed, and the [1 Section] mode is taken.
Facet and 1 Section cannot be started simultaneously.
4. When [Wire Combine]command is done with [Sweep Surface].
F7 key is pushed, and the [Sweep Surface] mode is taken.
5. When [Wire Combine]command is done with [Wire Section Delete Off].
F8 key is pushed, and the [Wire Section
Delete Off] mode is taken.
6. It starts [Wire Combine] command.
7. It chooses the object (Wire(Sweep Base Line)). (For the details, refer
to The way of choosing object.)
8. It starts [Wire Combine] command.
9. The check dialog of rotation of a section is displayed. A push on Yes
rotates 90 degrees of sections. It will end, if No is pushed.
When A and B are two or more selections, only the number of two or more
selections generates Sweep. Solid Facet can be set up if a function key
is pushed. refer to Solid and Facet. By Sweep Mode, the sweep surface (the
surface where the section
is uniform) can be generated. For the details, Sweep Surface.
