It sets (belonging) chosen object to the specification group.

TOOL

When starting this command, the command which was starting before it is automatically ended.
A procedure is shown below.
1. It chooses the object. (For the details, refer to The way of choosing object.)
2. The function key corresponding to a group to set(belonging) is pushed.(Group1 - 8 = F5 - F12 /9-16 CTRL＋F5−F12)
Two or more group setup is also possible at once.
3. It starts [Set Group] command.
One piece of object can be set to more than one group, too.
It is displayed on a status bar as which group the object is set.(For the details, refer to States Bar.)
The operation of Group, refer to The operation of Group.