When starting this command, the command which was starting before it is automatically ended.
A procedure is shown below.
1. A object is copied by the [Copy] command or the [Cut] command.
2. It starts [Paste] command.
3. In the case of a object selection state
[Paste Base Position]Dialog Box
If it clicks or drags, the solid copied to the intersection position of a selection object will be stuck.
It is the [Paste Base Position] Dialog Box when the [Numeric Mode] command
is started at this time. The crossing
position to the solid displayed and chosen can be specified.
4. In the case of a object not selection state When it drags or mouse clicking
, the object copied on that plane coordinate is pasted.
