|
It does the forming simulation of the chosen object.
| TOOL |
 |
When starting this command, the command which was starting before it is automatically ended.
A procedure is shown below.
1. It chooses the object. (For the details, refer to The way of choosing
object.)
2. It starts [Simulation] command.
3.The numerical value of the size correction is set in [size correction ]
dialog box.
（a）Size Correction
When pushed Bottan is size correction
（b）X-YCorrection value
Correction value of direction of X-Y (horizontal) when size is corrected
（c）Z correction value
Correction value of direction of Z (vertical) when size is corrected
4.The forming parameter is set in a [forming parameter] dialog box.
（a）Slice interval
The interval to do product layer (repeating a coating). [Generally, it
is 50-70 micrometer.]
（b）Hatching Interval
The interval to paint by painting a horizontal plane. [Generally, it is
30-50 micrometer.]（c）Hatching
It changes paint/non-paint the inside of the object.
(d) Hatching at Interval
The interval in the inner coating layer when painting the inside. (In case of 0, it paints all the layers).
5. In the forming parameter, after setting, it begins a simulation.
During simulation, the DIALOG of the progress is displayed. When stopping a simulation on the way, click the right
button of the mouse
(a)end Nc displey ,next Forming time.
(b)Save Nc data and end .
(c)It displays it by continuance again.
6. forming time parameter is displayed in [forming time parameter] dialog
box.
（a）Z Revising value
The revision value to the direction of Z (perpendicular) when revising
in the size
（b）AddWiper Time
It change total/non-total a wiper time.
（ c）Choose machine (Meiko System)
7.The DIALOG by which forming estimate time was written down behind the simulation is displayed.
In the forming time which was estimated by this command, it is a theory
value. Actually, a few errors occur with the time that there was a forming
in the optical forming equipment.
|
